Filter
Top Products
128-6864
9 of 16
-9-
CD PLAYER ERROR CODES
If a problem should develop while operating the CD player, an error code (ER-1, ER-2, ER-3, etc.) may appear on the display panel.
This can indicate a number of problems with the unit, including a mechanical error or an error in the microprocessor control of the
player. If an error code should appear, try ejecting and re-loading the disc into the player. While the disc is out of the unit, make sure
it is clean, undamaged, and loaded correctly (label surface up). You may also try activating the RESET button dn on the unit, but
this will also erase the time and pre-set memories.
If the suggested measures do not solve the problem, contact an approved warranty station near you for further assistance.
1. Switch the vehicle ignition and radio “on”.
2. Press the Display (T/F) button to call the time display; then press and hold the button until a beep tone occurs and the time display
flashes.
3. While the display is flashing, press the Up TUNE/SEEK/TRACK ( ) button to adjust the hours and AM/PM indication, or the
Down TUNE/SEEK/TRACK ( ) button to adjust the minutes to the correct time.
4. Five seconds after the last hour or minute adjustment is made, the time will be set in the unit and the display will return to the
normal indication.
SETTING THE CLOCK
CD EJECT
BUTTON (27)
FRONT PANEL
MOUNTING PLATE
GUIDE (2 PLACES)
PANEL MOUNTING
PLATE
RESET BUTTON
(32)
THEFT DETERRENT
LED (31)
DISC SLOT
(19)