Filter
Top Products
12
Power button (when using FM modulator and commander)
When turning on the power again (beginning to play the disc again), you are advised to
set the FM radio receiver at 88.7 MHz or 89.1 MHz (the frequency selected by Frequency
Select switch on the FM modulator). Then press the power button. The disc begins to
be played from the position where previous play was stopped.
Note :
When you want to listen in a different car stereo mode (radio mode or CD mode), turn off
DVD CHANGER power. Otherwise, excessive radio noise or receiver trouble could result.
When DVD CHANGER is directly connected with the receiver of a CD switching
controller
Please turn off the car stereo or switch to other modes (radio mode, CD mode, etc.).
If you want to turn on the power again (play again), follow the procedures below.
Then, the disc begins to play from the position where the previous play was stopped.
In case the power for car stereo is off, turn it on. (In case the device mode is not set up,
press the Enter button of the switcher mode.)
When you listen another car stereo mode (radio mode or CD mode), press the Car
Stereo Switcher select button.
Note.
Do not use the power button for remote control.
Please refer to the car stereo manual.
Power button
Power OFF