Filter
Top Products
49
The image is displayed.
No sound
Poor sound or image
quality
The remote control
will not work.
Brightness may be set lowest.
The parking brake is released.
The wire connection may be
wrong.
Set the volume at the lowest.
Wrong connection
You may have set fast forwards or
backwards play, pre-frame or slow
play.
Filthy or scratched disc
Vibration may occur at the position
where the switcher is installed.
Poor color or tone of the image
The LED transmitter of remote
control may not aim at the receiver
of the control sensor.
The remote control may be far
away from its sensor.
The photo space between remote
control and its sensor may be
blocked.
The battery may be discharged.
The battery may not have been
correctly inserted.
Adjust the brightness adequately.
If the parking brake is not released,
the monitor linked to the front seat
video output will not display the image.
Check the connection.
Adjust the volume of car stereo or
monitor connected with the device.
Check the connection.
No sound will be generated during fast
forwards or backwards play, pre-frame
or slow play.
Clean the disc. Do not use a scratched
disc.
When the device vibrates, the sound
may be interrupted. When vibration
stops, the device will work normally.
The monitor may have been aged or
deteriorated.
The photo emission point should aim at
the photo receiver.
The remote control should be used
within 3 meters (10feet) from its sensor.
Any obstruction should be cleared.
Replace the battery.
Check the polarity +/-) and insert the
battery correctly.