Filter
Top Products
-7-
co REPEAT PLAY SELECTOR (RPT)
During disc play, press this button to repeat the play of the se-
lected track (RPT will appear on the display panel). Play of the
track will continue to repeat until the button is pressed again and
the RPT indication disappears from the display panel. Repeat
Play mode will also be canceled by activating the Track Scan
cn or
Random Play
cp functions.
cp RANDOM PLAY SELECTOR (RND)
During disc play, press this button to play the tracks on the disc in a
random shuffled order (RND will appear on the display panel). In Random
Play mode, the TRACK Select function
bu will also select tracks in the
random order instead of the normal progression. The Random Play mode
can be canceled by pressing the button again (RND indication will disap-
pear from the display panel) or by activating the Repeat Play
co or
Track Scan
cn functions.
cq DISC SELECT UP/DOWN (D.UP/D.DN)
These buttons are used to select the desired disc for play during changer
operation. To advance to a higher number disc, press the D.UP button,
and to return to a lower number disc, press the D.DN button. The num-
ber of the disc in play will be shown on the display panel.
cr DISC EJECT (EJECT)
Disc play is stopped and the disc is ejected when the EJECT but-
ton is pressed. It is necessary to first lower the panel (Front
Panel Control)
2 before ejecting the disc. Radio or CD
changer operation will automatically resume depending on which
mode was in operation prior to disc play. If the disc is not removed
from the unit within 15 seconds of being ejected, it will automati-
cally be re-loaded into the unit to prevent it from being accidentally
damaged (
will appear on the display panel to indicate that a disc
is loaded in the player). Play of the disc can be resumed by using
the MODE button
bs to choose CD player function.
cs TIME/FREQUENCY SELECTOR (T/F)
During radio operation, press this button to call the time display on
the incorporated quartz clock. The current time will appear to-
gether with an AM or PM indication. The display will return to the
radio frequency indication after 5 seconds.
During CD player operation, press this button to call the time dis-
play. During CD changer operation the pressing the button will call
the time display. In either case, the display will return to the disc
indication after 5 seconds.
ct EQUALIZER BUTTON (P
l
EQ)
The P
l
EQ button applies preset sound effects to the unit’s audio
output signal. The P
l
EQ button, when pressed, will activate one of
three operating modes (ROCK, CLAS, or POP). When the P
l
EQ
function is active, as displayed on the panel, the bass and treble
levels cannot be changed. When the P
l
EQ function is not active, the
unit returns to the user set bass and treble levels.
cu RESET BUTTON
The RESET button is located on the front panel. The reset circuitry
should only be activated under the following circumstances as it
will erase the time and pre-set memories:
1. Upon initial installation after all wiring is completed.
2. If there is a malfunction of any of the switches on the unit,
pressing the RESET button may clear the system and return
to normal operation.
dl REMOTE SENSOR
The sensor to detect the infrared signal from the wireless remote
control is located behind the VFD display lens. For optimum op-
eration of the remote control, always aim the control at the VFD
display.