Filter
Top Products
Turning the PROVD8 On or Off
1. Sliding the screen release lock forward will unlock
the LCD screen and it will drop down slightly. Pivot
the screen downward until a comfortable viewing
angle is reached. The internal friction will hold the
screen in position while the system is in use.
2. Pressing the power button on the unit or the remote
control will turn the system on or off alternately. When
in use the internal backlighting will illuminate the
controls.
3. After the unit has been turned on and is displaying a
picture, adjust the viewing angle, by pivoting the screen
to optimize the picture quality.
4. Remember to turn the unit off and pivot the LCD to
the locked position when not in use.
-8-
CHANNEL TUNING SET UP
In order to easily access all available TV channels, it
may be necessary to perform channel auto-programming
whenever the vehicle’s geographic location has changed,
i.e. city to city, weak signal area.
Use the Source Select Button on the Remote Control to
select TV mode.
1. Press the AUTO MEMORY button on the Remote
Control Unit or the AUTO PROGRAM button on the
drop down video unit. You will see the TV cycle
through all its channels. The built-in micro-processor
will automatically store each channel that is actively
broadcasting in your area.
2. (A) To tune only strong clear channels with the
CHANNEL UP/DOWN buttons, press the SKIP/
SEARCH button on the Remote Control Unit until
“SKIP MODE ON” is displayed on the bottom of the
screen. The TV will now tune only to strong active
channels when the UP or DOWN buttons are used
on the monitor or remote control.
3. (B) To tune weak or marginal channels with the
CHANNEL UP/DOWN buttons , press the SKIP/
SEARCH button on the Remote Control Unit until
“SKIP MODE OFF” is displayed on the bottom of the
screen. Tune to the desired channel using the
CHANNEL UP/DOWN buttons or go directly to the
channel by using the 0-9 buttons on the Remote
Control.