Filter
Top Products
Overhead Dome Lights
The Dome lights integrated into the PROVE8 are
controlled by a three position slide switch. Sliding the
switch to the on position will turn the lights on. The off
position will prevent the lights from turning on at all
times, and the auto position will allow the lights to turn
on and off with the vehicle’s interior lighting. Refer to
the Installation Manual for the wire connections. Do
not leave the vehicle unattended with the dome light
switch in the on position, as this could result in a
discharged battery.
Dome
Light
Switch
POWER E JEC T REV PLAY FWD STOP
CHA NNEL
AU TO
PROGRAM
SOURCE
SELECT
PICTURE
SELECT
VOLUME
ON OFF AUTO
I
R
I
N
P
U
T
A
U
D
I
O
L
R
V
I
D
E
O
H
E
A
D
P
H
O
N
E
S
3. (B) To tune weak or marginal channels with the CHANNEL UP/DOWN buttons , press the SKIP/SEARCH button on the
Remote Control Unit until “SKIP MODE OFF” is displayed on the bottom of the screen. Tune to the desired channel
using the CHANNEL UP/DOWN buttons or go directly to the channel by using the 0-9 buttons on the Remote Control.
4. To ERASE a channel, press the ERASE/WRITE button on the Remote Control Unit until “MANUAL MEMORY XX
ERASE” is displayed on screen. To STORE a channel, press the button until the MANUAL MEMORY XX ADD is
displayed on screen.