Filter
Top Products
128-7472
8 of 16
-8-
NOTE: Allow a 72-hour period for the adhesive
backing to cure completely.
CAUTION: Do not install the swivel bracket
on a leather or fabric surface, or
in a position that could impair
your vision, block air bag(s) or
obstruct vehicle dashboard
controls and/or radio CD/
cassetteoperational displays.
NOTE: The adhesive backing on the bracket
will not permit easy repositioning once
it has been mated to the surface; use
extreme care and planning when
selecting the mounting location. If the
bracket is to be screwed to the surface,
make sure the area in back of the
mounting surface is clear of wires or
other items to prevent unintentional
damage.
c. Using the alcohol swab supplied with your kit,
clean the mounting surface and thoroughly wipe
the area dry with a clean lint-free cloth.
d. If the outside air temperature is cold, it may be
beneficial to warm the adhesive backing on
the bracket using a portable hair dryer, or by
holding the backing surface in front of a
vehicle heater vent.
e. Remove the plastic liner from the adhesive
backing on the bracket, and fix the base in
position on the surface; make sure the
mounting pad is accurately positioned on
the first try, since repositioning may be
difficult, if not impossible.
f. If the bracket is to be screwed in place, do
not remove the plastic liner from the
adhesive backing. Use appropriate sheet
metal or machine screws for this purpose.
g. To mount the XMC10 cradle atop the swivel
bracket, line up the slot at the rear of the cradle
with the bracket retainer tab, and slide the cradle
down so that the slot and tab mesh together in
a locked position.