Filter
Top Products
AXIS P7216 Video Encoder
Connectors
For specications, see page 10.
BNC connector - Each video input is terminated using a coax/BNC connector. Connect a 75 Ohm
coaxial video cable; the recommended maximum length is 800 feet (250 meters).
Note
75 Ohm video termination can be enabled/disabled for the video input via the product's
web page at Video & Audio > Video Input > Video termination. This termination is enabled
on factory default. In cases where the product is to be connected in parallel with other
equipment, for optimum video quality, it is recommended that termination be enabled for
only the last device in the video signal chain.
Network connector - RJ45 Ethernet connector.
SFP connector - The unit can only use one Network interface, either an SFP module or RJ45
connector. SFP module has higher priority than the RJ45 connector.
NOTICENOTICE
NOTICE
The product shall be connected using a shielded network cable (STP). All cables connecting
the product to the network switch shall be shielded (STP) and intended for their specic
use. Make sure that the network switch is properly grounded. For information about
regulatory requirements, see Regulatory Information, on page 2 .
Audio in (pink) - 3.5 mm input for a mono microphone, or a line-in mono signal (left channel is
used from a stereo signal).
Audio out (green) - 3.5 mm output for audio (line level) that can be connected to a public address
(PA) system or an active speaker with a built-in amplier. A stereo connector must be used for
audio out.
SD card slot - A standard or high-capacity microSD card (not included) can be used for local
recording with removable storage.
NOTICENOTICE
NOTICE
To prevent corruption of recordings, the SD card should be unmounted before removal. To
unmount, go to Setup > System Options > Storage > SD Card and click Unmount.
Control button - The control button is used for:
• Resetting the product to factory default settings. See page 14.
• Connecting to an AXIS Video Hosting System service or AXIS Internet Dynamic
DNS Service. For more information about these services, see the User Manual.
9
ENGLISH