Filter
Top Products
MFGD 3220D User's Guide 12
2.4 Connecting the signals
To get access to the connectors, open the cover
of the connector compartment by pulling down the
2 clips of the cover.
To connect the video & sync signals:
1 Connect one end of the video cable to the
DVI input (5) of the display.
2 Connect the other end of the video cable to
the video output of your video source
(Computer graphics board with digital video
output).
3 Route the cable so that it enters the
connector compartment at the place where
the cover is bulged.
Vid1
Vid2
Example of signal connection in a Coronis dual-
head system
To connect the power:
1 Connect the output of the 12V DC power
supply to the DC input (6) of the display.
2 Connect one end of the proper power
cable to the AC input of the 12V DC power
supply.