Filter
Top Products
MFGD 3220D User's Guide 13
2.5. Routing the signal cables
After connecting all cables, fix them in the cable
tie at the rear of the connector compartment. You
can also bind the cables together by means of the
2 velcro strips included in the package.
After fixing the cables, put the connector
compartment cover back in place. Pay attention
that the signal cables are positioned under the
bulge in the cover.
Next, fix the cables in the plastic clamps on the
foot. At last, put the foot cover back in place.
To put the foot cover in place:
1 Push the upper side of the cover onto the
foot, so that the hooks on the cover are
positioned right under the holes in the foot.
2 Slide the cover upward while moving the
lower side of the cover towards the foot.
3 Press the cover to the foot so that both clips
make a clicking sound.
3 Connect the other end of the power cord to
a grounded power outlet.
Push the upper side of the
cover onto the foot
Signal cables routed under foot
cover and bound by velcro strips
Connector
compartment