12 13XENYX QX2442USB Quick Start Guide
XENYX QX2442USB Controls
(1)
(2)
(3)
(6)
(9)
(7)
(8)
(5)
(4)
(21) (22)
(19)
(20)
(14)
(16)
(15)
(13)
(18)
(17)
(10) (11) (12)
(EN) Step 2: Controls
(1) USB wireless input accepts a USB
receiver for use with BEHRINGER ULM
wirelessmicrophones.
(2) GAIN knob adjusts the sensitivity of the MIC
and/or LINE inputs.
(3) COMP knob adjusts the amount of
compression eect on the channel.
(4) EQ knobs adjust the high, mid and low
frequencies of the channel. Adjust the FREQ
knob to select the specic frequency adjusted
by the MID knob.
(5) AUX knobs adjust how much of the channel’s
signal routes to the AUX SEND jacks.
Pressthe PRE button when routing the
signal to a stage monitor. Use the FX knob
to send the channel’s signal to the internal
multi-FX processor.
(6) PAN/BAL knob positions the channel in the
stereo eld.
(7) MUTE button mutes the channel.
(8) CLIP LED lights when the channel
signaloverloads.
(9) CHANNEL FADER adjusts the channel volume.
(10) AC IN accepts the included power cable for
connection to a mains outlet.
(11) POWER ON switch turns the mixer on
and o.
(12) PHANTOM ON switch sends 48V
to the XLR inputs for use with
condensermicrophones.
(13) MULTI-FX PROCESSOR adds a selected
sound eect to any channels whose
FX knob is turned up. See the Multi-FX
Processor section for details.
(14) AUX SENDS adjust the amount of signal
sent to a monitor speaker or external
eects processor via the AUX SEND jacks.
(15) AUX RETURNS adjust the amount of
signal returning from an external eects
processor that is included in the main mix.
Use the TOAUX SEND knob(s) to include the
eects signal in your monitor mix as well.
(16) SOURCE buttons route the USB/2-TR,
SUB, and MAIN MIX to the PHONES and
CONTROLROOM jacks.
(17) USB/2-TR TO MAIN button routes the
USBand 2-TRACK signal to the MAIN MIX.
(18) PHONES/CTRL ROOM knob adjusts the
headphone or studio monitor volume.
(19) VU METER displays the MAIN OUTPUT
signal level.
(20) MODE button determines whether
the channel’s SOLO button operates as
‘Soloin Place’ (button out) or ‘Pre-Fader
Listen’ (button in). PFL is preferred for gain
settingpurposes.
(21) SUB faders adjust the output of the
SUBOUTPUT jacks. Use the LEFT/RIGHT
buttons to assign the SUB signal to the left
and/or right MAIN MIX.
(22) MAIN MIX fader adjusts the overall output
of the mixer.