Blaupunkt 7 644 262 310 Car Stereo System User Manual


 
40
Switching on by inserting a CD
If the device is switched off and there is
no CD present in the drive,
press the button 2.
The flip-release panel opens.
Gently insert the CD with its printed
side uppermost into the drive until
you feel some resistance.
The drive draws in the CD automatical-
ly.
You must not hinder or assist the drive
as it draws in the CD.
Gently close the control panel
whilst exerting a little pressure until
you feel it click into place.
The device switches on and starts play-
ing the CD.
Note:
If the ignition was switched off be-
fore you inserted the CD, you will
first have to switch on the device
by pressing button 1 in order to
start playing the CD.
Adjusting the volume
You can adjust the volume in steps from
0 (off) to 66 (maximum).
To increase the volume,
turn the volume control 5 clock-
wise.
To decrease the volume,
turn the volume control 5 anti-
clockwise.
Setting the power-on volume
You can set the device’s default power-
on volume.
Press the MENU button 9.
Press the or button 7 repeat-
edly until “ON VOLUME” appears
in the display.
Adjust the power-on volume using
the buttons 7.
To help you adjust the setting more eas-
ily, the device will increase or decrease
the volume as you make your changes.
If you change the setting to “LAST VOL”,
the volume when the device switches
on will be the same as the volume level
that was set the last time you switched
the device off.
Note:
To protect your hearing, the power-
on volume is limited to a value of
“38”. If the volume level was higher
than this when the device was last
switched off and the “LAST VOL”
setting is activated, the system will
reset the volume to “38” when you
switch the device on again.
SWITCHING ON/OFF
ADJUSTING THE VOLUME