Filter
Top Products
19
ACR 3251 GB
ENGLISH
DEUTSCH
FRANÇAIS
ITALIANO
NEDERLANDS
SVENSKA
ESPAÑOL
PORTUGUÊS
• Select the waveband with the FM·T or
M·L button and for FM select the mem-
ory bank with FM·T.
Toggle FM·T until the desired memory
bank is indicated in the display.
• Select the desired preset button (1 to 6)
for the new station to be stored using
preset buttons 1-6.
• Tune in a station either automatically or
manually by pressing < or >.
• Press the desired preset button (1-6)
until the radio resumes play after the
muting and you hear the beep.
Now the station has been stored.
The activated preset button (1-6) is indicated
in the display.
Note:
If you select an already stored station, the
corresponding memory bank and preset but-
ton will flash in the display for about 6
seconds.
Automatically storing the
strongest stations with Travel-
store
You can automatically store the six most
powerful FM stations of your current recep-
tion area sorted according to their signal
strength.
When keeping the
or the button de-
pressed, seek tuning will speed up in up-
wards or downwards direction.
Manual tuning
Prerequisite: “m” lights up in the display.
Toggle the lo·m button until “m” is displayed.
• Press
; the frequency will change in
short intervals in upwards or down-
wards direction.
When holding the
or button down, the
frequency scan is speeded up.
Selecting the seek tuning sensi-
tivity
You can alter the automatic seek tuning
sensitivity.
For this,
• press the lo·m button briefly.
If “lo” is displayed, the radio will only pick up
strong, local stations (low sensitivity).
If “lo” does not light up, the radio will also pick
up weaker, distant stations (high sensitivity).
Make sure that “m” is not indicated in the
display.
Switching from stereo to mono
(FM)
If reception is poor, you may get better sound
quality by switching to mono:
• Press the lo·m button until a beep
sound is released and the stereo sign
disappears from the display.
Each time the radio is switched on, stereo
playback is activated ( is displayed).
The unit will automatically switch to mono if
the received signal is not strong enough for
stereo playback.
Changing the memory bank
You can shift between the memory banks I, II
and T in order to store stations and recall
them later.
The currently selected memory bank is indi-
cated in the display.
• Toggle the FM·T button until the desi-
red memory bank lights up in the dis-
play.
Storing stations
On FM, you can store six stations on the
preset buttons 1 to 6 for each of the memory
banks I, II and T. On MW/LW it is possible to
store six stations on each waveband.