Filter
Top Products
ENGLISH
E-3
General Operations
Turning the power On/Off
Press the
PWR
to turn the unit On or Off.
Volume Level Control and Memory
Rotate the VOL dial to adjust the volume.
It is also possible to set turn-on volume level by following the
procedure explained below.
1. Rotate the VOL dial until it is set at the required volume.
Volume up
Volume down
2. Press the
PWR
for two or more seconds. The power will
be switched off and the current volume level recorded.
Muting the sound
Press
MUTE / SENS
.
The R-ch/L-ch Level Meter flashes.
To restore the previous volume level, press
MUTE / SENS
again.
Setting the Clock
The clock uses a 12-hour display system.
1. Turn the ignition key to the ON position.
2. Press the
PWR
to turn on the unit.
3. Press and hold the
DISPLAY
for more than two seconds to
enter the Clock setting mode.
4. Use the following buttons and dial to set the clock. (The blink-
ing section can be adjusted.)
AUDIO
: To activated Hour blink
MUTE / SENS
: To activated Minute blink
: Adjust the Hour and minute
5. Press the
DISPLAY
momentarily to complete the Clock set-
ting mode.
Ignition-off Clock Recall
The display will illuminate showing the time and then auto-
matically shut off after 5 seconds.
Press the
DISPLAY
while the ignition switch is in the “ OFF ”
position.
Display Priority Selector
Each time the
DISPLAY
is pressed, the display window will
change as shown below ;
• Radio mode
Frequency and Clock.
• CD / CDC(CD changer) mode
Elapsed time and Clock.
BPV660(EN)_body 1/22/02, 10:48 AM3