Filter
Top Products
20
Detachable Face (Release Panel)
Detaching and Attaching the Face:
The face of this unit can be detached and taken with you to prevent it from being stolen.
Detaching the Face:
Press the REL (Release) Button and detach the face by gently pulling it off as illustrated.
Note: Do not pull it straight out from the chassis. Be sure not to drop the face when detaching it
from the chassis. Do not expose the face to direct sunlight, heat sources such as hot air ducts or
leave it in a humid place.
Attaching the Face:
Apply the right hand side of the face to the chassis by sliding (part B) of the face to (part A) at
the front of the chassis. Gently push the left side of the face against the front of the chassis until
it snaps into place.
Note: Make sure that the face is inserted right side up. Do not press against the display window.
Do not press hard against the face when attaching it to the chassis, it may be easily attached
with gentle pressure.
Affixing Faceplate For Retail Display:
The faceplate can be affixed to the unit’s chassis, which is desirable for a retail display, for
example. This should only be done in situations where the unit can be accessed from
behind the mounting surface. Once the faceplate is affixed, the release keys cannot be
used to remove the chassis.
To affix the faceplate:
Insert the black bolt into the hole at the left front of the top of the radio. See * below.
*
A
B
Lima CR47 gb® 13.05.2002, 10:37 Uhr20