Filter
Top Products
11
FRANÇAIS
ENGLISH
ESPAÑOL
PORTUGUÊS
RADIO MODE
Radio mode
Switching to radio mode
If you are listening to CD/MP3, CD
changer or AUX mode,
➮ press the BND•TS 4 button
or
➮ press the SRC button ; repeated-
ly until “FM” or “AM” (“MW”) ap-
pears in the display.
Setting the tuner
In order to guarantee the perfect func-
tioning of the radio element, the unit
must be set for the region in which you
are located. You can choose between
Europe (EUROPE), America (USA),
Thailand (THAI) and South America
(S-AMERICA). The tuner comes from
the factory set for the region in which
the unit was sold. Should you encoun-
ter problems with radio reception,
please check this setting.
This set of instructions refers to the
“USA” setting.
➮ Switch off the device by pressing
button 1.
➮ Press and hold down the 1 and 5
buttons 9 at the same time and
switch on the device again with
button 1.
“TUNER” is displayed.
➮ Press the or buttons 6 within
the next 8 seconds and select your
tuner region.
To save the setting,
➮ switch the device off and on again
or wait approx. 8 seconds. The ra-
dio starts with the last setting acti-
vated (radio, CD (MP3), CD chang-
er or AUX).
Selecting the frequency range/
memory
This unit can receive programmes
broadcast over the FM and AM frequen-
cy ranges. There are three memory
banks for the FM range and one for the
AM range. Six stations can be stored in
each memory bank.
Selecting the FM memory bank or
the AM frequency range
respectively
➮ Press the BND•TS button 4 to
switch between the FM memory
banks (FM1, FM2 and FMT) and
the AM frequency range respec-
tively.
Tuning into a station
There are various ways of tuning into a
station.
Automatic seek tuning
➮ Press the
or button 6.
The unit tunes into the next receivable
station.
Setting the sensitivity for station
seek tuning
You can configure the radio to only tune
into stations with a strong reception or
to also tune into those with a weak re-
ception.