Filter
Top Products
2 Channel Full-Range Mode
This installation is most popular for listeners who want to simply increase the power to the rear speakers in a car. The
resulting performance is most commonly a louder overall sound field from the rear.
But, such a system’s biggest benefit is the additional bass response since the bass control of the radio can be turned up
without distorting the amplifier. Such a system is not necessarily louder in the mids and highs but is able to play louder in
the low frequencies due to this additional power. This leads to an overall richer and stronger sound experience for the
listener without additional subwoofer boxes or electronics that may complicate the system or take up more room. Such a
system WILL NOT equal the performance of a subwoofer system but will certainly be a pleasant improvement.
SYSTEM CONFIGURATION #1
3 Channel Multi-Mode (Passive)
The multi-mode system is a “poor-man’s” satellite/subwoofer
system. This amplifier is able to drive speakers in stereo mode
and at the same time drive low frequencies to a dedicated
subwoofer speaker. By inserting inductors (coils) and capacitors,
the result is an inexpensive solution to generating a ‘3' channel
system with a 2 channel amplifier.
Using passive components (coils and capacitors) the installation
is simple and performs adequately for most listeners. Such a system will not perform as well as an “active” system because
the slow attenuation (roll-off) of the frequency response resulting in a moderate amount of over-lapping of the sound
spectrum between the satellites and subwoofers. It is important to remember that although surprisingly pleasant
performance is achieved, this is a compromise system and will NOT perform as well as a dedicated 3 channel system with
electronic crossovers.
SYSTEM CONFIGURATION #2
– 9 –
Full-Range
Full-Range
Full-Range
Full-Range
75flat100
Crossover
Position
X-OVER
+ L – + R –
Speakers
+ Bridged –
Full-Range
Full-Range
High-Pass
High-Pass
Subwoofer
75flat100
Crossover
Position
X-OVER
+ L – + R –
Speakers
+ Bridged –
Connect Speakers as shown. For best sound,
always make sure to connect + to + and - to -