Filter
Top Products
48
Automatic seek tuning start
(tape and CD changer operation)
When leaving the reception area of the
tuned in traffic programme station while
listening to a tape or CD, the system will
automatically start searching for a new TA
programme.
If no such station is found within approxi-
mately 30 seconds, tape or CD operation
will be stopped and a warning beep will
sound. To switch the warning beep off, pro-
ceed as described above.
Adjusting the volume for traffic
announcements and the warning
beep
This volume was preset at the factory,
though you can alter the value using the
DSC function (see “DSC programming, TA
VOL”).
Adjusting GEO for traffic
messages and the warning beep
You can separately adjust the balance and
fader settings for both traffic announcements
and the warning beep.
For example, it is possible to listen to traffic
reports via the front left (right) speaker only.
Warning beep
If you leave the reception area of the traffic
programme station currently tuned into, you
will hear a warning beep after approximate-
ly 30 seconds.
This alarm tone will also be released when
pressing a preset button which has no traf-
fic programme allocated to it.
Switching the warning beep off
a) Tune into another station offering traf-
fic information:
• Press the rocker switch or
• press a preset button which has a
traffic programme station allocated
to it.
Alternatively:
b) Switch off the priority for traffic an-
nouncements:
• Press TIM for approximately two
seconds until you hear a beep.
“TA” will disappear from the dis-
play.
This provides the driver with the important
traffic information without bothering the rear
passengers too much.
To make a setting:
• During an announcement, adjust the
balance and fader settings to suit your
personal preferences.
Stockh. RCM126 gb® 30.04.2002, 15:25 Uhr48