Filter
Top Products
32
Changing the memory bank (FM)
You can shift between the memory banks I,
II and T in order to store stations and recall
them later.
The currently selected memory bank is in-
dicated in the display.
• Press the TS/BND button as many
times as necessary until the desired
memory bank lights up in the display.
Storing stations
On FM, you can store five stations on the
preset buttons 1, 2, 3, 4, 5 for each of the
memory banks I, II and T.
On MW/LW, you can also store five stations
each.
• Select the desired memory bank with
TS/BND.
• Tune in a station with the rocker switch
(either automatically or manually).
• Press and hold down the desired pre-
set button until the radio resumes play
after the muting (takes approximately
1 sec., confirmed by a beep).
Now the station has been stored.
The activated preset button is indicated in
the display.
Station tuning
Automatic tuning /
• Press / ; the car radio will automati-
cally search for the next station.
If you hold down the upper or lower part
/ of the rocker switch, seek tuning will
speed up in the upwards or downwards di-
rection.
Automatic tuning
Up
Down
Down in short intervals (if “AF” is off)
Up in short intervals (if “AF” is off)
Manual tuning with << >>
You can also tune in a station manually.
Condition:
AF must be switched off (i.e. the symbol
does not light up in the display).
If necessary, deactivate AF:
• Press AF/TA for approximately 1 sec.
Manual tuning:
• Press << >>; the frequency will change
in short intervals in the downwards or
upwards direction.
If you hold down the right or left part of the
rocker switch, the frequency scan will speed
up.
Scrolling through the broadcast
networks (only FM)
You can use the << >> buttons to tune in
stations of your reception area.
If several programmes of the broadcast net-
works can be received, you can scroll
through them forwards by pressing >>, or
backwards using the << button, e.g. NDR
1, 2, 3, 4, N-JOY, FFN, ANTENNE ...
For this it is necessary that the stations have
been tuned in at least once and that “AF” is
active (lights up in the display).
For this purpose, start automatic tuning, e.g.
using Travelstore:
• Press TS/BND for 1 sec.; the system
starts to run through the frequency
band. The display shows “T-STORE”.
If “AF” does not light up,
• Press AF/TA for approximately 1 sec.
This fulfils the requirements for selecting
stations with << >>.
Saint Malo RCM127 gb® 16.05.2002, 13:41 Uhr32