Filter
Top Products
23
ENGLISH
DEUTSCH
FRANÇAIS
ITALIANO
NEDERLANDS
SVENSKA
ESPAÑOL
PORTUGUÊS
3 AUD
To adjust the treble, bass, balance and
fader.
If the display shows “TRE” or “BAS”,
you can adjust the playback of the tre-
ble and bass frequencies using the
rocker switch. If “BAL” or “FAD” is dis-
played, you can set the balance (left/
right) and fader (front/rear).
Press AUD as many times as required
and make the setting using the rocker
switch.
Treble + / Fader front
Treble – / Fader rear
Bass – / Balance left
Bass + / Balance right
The last setting will be stored automat-
ically.
To switch off AUD: Press button once
again.
If you do not change the setting within
8 seconds, the display will switch back
to the previous condition.
Switching on when the ignition is
switched off:
To keep on operating the set when the
ignition is switched off:
Press ON. The unit will be turned on.
To save battery power, the system will
be turned off automatically after one
hour of playback.
Extra function of ON button
You can instantly turn down the vol-
ume by pressing ON briefly. “MUTE”
will appear. The volume will be set to
“VOL 0”. The function is cancelled by
pressing ON or VOL+ briefly.
If VOL- is pressed, the mute volume
will be adopted.
2 VOL+ / VOL-
To alter the volume.
Each time you switch the unit on, it will
play at the preset volume (VOL FIX).
You can also change the VOL FIX set-
ting (see “DSC programming”).
Quick reference
1 Switching on/off with the ON button:
Press ON.
The unit will play at the preset volume.
If the unit is switched off, a double
beep tone will remind you that you
should remove the detachable face
before leaving your vehicle.
Note:
Read the information in the section on
“Theft protection system”.
Switching on/off via the ignition:
If connected accordingly, the set can
also be turned on and off with the vehi-
cle ignition.
Saint Malo RCM127 gb® 16.05.2002, 13:41 Uhr23