Filter
Top Products
32
• Select the appropriate waveband by
pressing BA/TS.
• Tune in a station with the rocker switch
(either automatically
/ or manually
<< >>).
• Press the desired preset button until
the radio resumes play after the mut-
ing (takes approximately 2 seconds,
confirmed by a beep).
Now the station has been stored.
The display will indicate which preset but-
ton is currently activated.
Automatically storing the
strongest stations with Travel-
store
You can automatically store the six most
powerful FM stations in your current recep-
tion area sorted according to their signal
strength. This function is particularly conven-
ient on longer trips.
• Press the BA/TS button for 2 seconds.
“T-STORE” will appear in the display.
The six strongest FM stations will be auto-
matically stored on the memory bank “T”
(Travelstore). When this process has been
completed, the radio will play the strongest
station.
If desired, stations can also be stored man-
Manual tuning with << >>
You can also tune into a station manually.
Requirement:
AF and PTY must be switched off (i.e. the
symbols do not light up in the display).
If necessary, deactivate these functions:
• Press AF·TA or PTY.
Manual tuning:
• Press << >>; the frequency will change
in short intervals in the downwards or
upwards direction.
If you hold << >> pressed to the left or the
right on the rocker switch, the frequency
scan will speed up.
Scrolling through the broadcast-
ing networks (FM only)
You can use the << >> buttons to tune into
stations in your reception area.
If it is possible to receive several pro-
grammes in the same broadcasting network,
you can scroll through them in the forwards
direction by pressing >>, or backwards
using the << button, e.g. NDR 1, 2, 3, 4,
N-JOY, ...
For this to work properly you must have al-
ready tuned into the stations at least once
and “AF” must be active (lights up in the dis-
play).
To do this, you can start the Travelstore seek
operation:
• Press BA/TS for 2 seconds; the sys-
tem will start to run through the fre-
quency band.
If “AF” is not lit up,
• Hold AF·TA down. A beep sounds and
“AF” appears.
This fulfils the requirements for selecting
stations with << >>.
Switching between the memory
banks (FM)
You can switch between the memory banks
1, 2 and T in order to store stations and re-
call them later.
The currently selected memory bank ap-
pears in the display.
• Press the BA/TS button as many times
as necessary until the desired memory
bank lights up in the display.
Storing stations
On FM, you can store six stations on the
preset buttons 1, 2, 3, 4, 5, 6 for each of the
memory banks (1, 2, T).
On MW/LW, you can also store six stations
each
(Zermatt RCM 149 without MW, LW)
.