Filter
Top Products
33
ENGLISH
DEUTSCH
FRANÇAIS
ITALIANO
NEDERLANDS
SVENSKA
ESPAÑOL
PORTUGUÊS
To select a scanned station and switch
off the Scan function:
• Press SRC/SC briefly.
If no station is selected, scan will start again.
Changing the scan time
The scan time can be selected from between
5 to a maximum of 20 seconds.
If you would like to alter the scan time,
please refer to the section on “DSC program-
ming - SCANTIME”.
Selecting the automatic tuning
sensitivity
You can alter the automatic tuning sensitiv-
ity.
If “lo” is displayed, the radio will only pick up
strong, local stations (low sensitivity).
If “lo” does not light up, the radio will also
pick up weaker, more distant stations (high
sensitivity).
If you would like to alter the sensitivity level
please refer to the section on “DSC program-
ming – SENS”.
PTY - Programme Type
PTY is an RDS service offered by an in-
creasing number of broadcasting stations.
This feature allows you to select FM stations
according to their programme type.
After you have chosen the PTY of your pref-
erence, the corresponding stations can be
selected either by seek tuning or using the
scan function.
Programme types
Turn PTY on.
Use << >> to have the last selected pro-
gramme type displayed and to choose a new
one.
You can select any one of the stored types
with the preset buttons 1-6.
The following list indicates some of the pro-
gramme types which are available.
WEATHER
FINANCE
TRAVEL
HOBBIES
JAZZ
COUNTRY
NEWS
INFO
SPORT
ually in the Travelstore bank (see “Storing
stations”).
Recalling stored stations
You can recall any stored station at the touch
of a button.
• Select the waveband by pressing
BA/TS. For FM, also choose the corre-
sponding memory bank by pressing
the BA/TS button as many times as
necessary until the desired bank ap-
pears in the display.
• Press the corresponding preset button
briefly to recall the station.
Scanning stations with
Radio Scan
You can scan through all of the stations in
your reception area.
To start the Scan function:
• Press SRC/SC longer.
The scanned frequency or the station name
will start flashing in the display.
During the actual scanning process “SCAN”
will appear in the display.