Filter
Top Products
Canberra RCM 85
28
To select a station currently being
scanned and switch off Preset Scan:
• Press SC/MIX briefly.
Scanning stations with
Radio-Scan
Beginning with the station currently tuned in,
you can scan the waveband. The radio will
play each station for 8 seconds.
To start the scan:
• Press SC/MIX briefly.
The scanned frequency or the station
name will start flashing in the display.
During the actual scanning process
“SCAN” will be displayed.
To select a station currently being scan-
ned and switch off the scan function:
• Press SC/MIX briefly.
If no station is selected, the scan function will
be automatically switched off after the fre-
quency band has been run through comple-
tely. The unit will tune in the station listened
to before starting the scan.
Notice:
Should you tune in a station which has alrea-
dy been stored before, the corresponding
preset button and the memory bank will briefly
flash in the display if you have selected
another memory bank.
Automatically storing the stron-
gest stations with Travelstore
You can automatically store the six most
powerful FM stations of your current recepti-
on area sorted according to their signal
strength. This function is particularly conve-
nient on longer trips.
• Press the FM
T button for more than
2 seconds.
The radio will search for the strongest FM
stations and store them on the memory bank
T (Travelstore). When this process has been
completed, the radio will play the first station.
If desired, stations can also be stored manu-
ally on the Travelstore bank (see “Storing
stations”).
Recalling stored stations
You can recall any stored station at the touch
of a button.
• Select the waveband by pressing FM
T
or M•L. On FM, also choose the corre-
sponding memory bank by pressing the
FMT button as many times until the
desired bank appears in the display.
• Press the corresponding preset button
briefly to recall the station.
Scanning stored stations
with Preset Scan
You can have all of the stored stations played
briefly on all wavebands.
On FM, you can scan the stations of the
Travelstore memory bank or of the two other
storage levels.
• Select the waveband.
• On FM, choose Travelstore or another
memory bank using the FM
T button.
To start Preset Scan:
• Press SC/MIX for approximately 2 se-
conds.
The stations will be played for approximately
8 seconds each.
The positions blinking in the display show
you the memory bank and preset position of
the currently scanned station.