Filter
Top Products
Canberra RCM 85
32
DSC programming
DSC (Direct Software Control) allows you to
customise certain programmable, basic set-
tings to suit your personal needs and prefe-
rences and then store them.
The basic settings for this audio equipment
were made at the factory. In the following you
can find an overview of these settings, so that
you can always reset to these if desired.
If you wish to alter any of the programming,
• press DSC.
The display will show you the adjusted con-
dition.
Use the rocker switch to select and adjust the
functions described in the following.
/ Select function
Adjust value –
Adjust value +
LOCAL (lo)
To adjust the seek tuning
sensitivity for local recepti-
on.
LOCAL 1 - high sensitivity
LOCAL 3 - low sensitivity
DIS (dx)
To adjust the seek tuning
sensitivity for distant recep-
tion.
DIS. 1- high sensitivity
DIS. 3- low sensitivity
TIME ON/OFF To select the display mode
during CD changer opera-
tion (option).
TIME ON - display of title
and playback time.
TIME OFF - display of CD
and title number.
If SCAN or MIX is active,
the system will always
switch to the TIME OFF
mode.
TA VOL To adjust the traffic an-
nouncement volume from
between 1 to 9. The mes-
sage will then come
through at this volume.
(1 = low)
BEEP Confirmation tone for all
functions which require a
button to be pressed for
more than 2 seconds.
The volume can be adju-
sted from between 0 to 9.
(0 = off)
Each alteration of this value
is confirmed by a beep tone
of the corresponding volu-
me.
LED (code) You can adjust the LED C
to flash for extra anti-theft
protection.
LED 1 - LED always flash-
es when the unit
has been swit-
ched off via the
ignition.
LED 0 - No flashing.
LOUD Loudness - When listening
at a low level, the Loud-
ness function creates a
more natural sound by
boosting the low frequency
range.
LOUD 1- Low boost
LOUD 6- Max. boost