Filter
Top Products
54
Storing the display mode
You can store your preferred display mode
which will then be active each time the ra-
dio is switched on.
If required,
• press AF as many times until the de-
sired setting is displayed.
• Hold down the AF button until you hear
a beep.
SCAN operation
Use this function to scan all of the CD tracks.
For CDC operation, the system will scan the
titles of all discs.
To start the Scan function:
• Press SC/MIX for approximately one
second.
The titles will be scanned one after the oth-
er in ascending order.
To stop the Scan function:
• Press SC/MIX once again briefly.
The track currently being scanned is con-
tinued to be played.
SCAN will also be terminated by
• pressing one of the buttons AUD,
GEO, DSC, SRC, TPM,
,
<< >> or
/ .
TPM Track Program Memory
Use this feature to programme and play your
favourite CD titles.
Up to 30 CDs can be managed in the CD
mode, up to 99 discs in the CDC mode.
Storing tracks with TPM
Make sure that the TPM function is switched
off (“TPM” not shown on the display panel).
If you have not yet stored a track in the TPM,
the function will be unavailable.
If required,
• switch TPM on/off by pressing the
TPM button.
• Use
/ to select a track. The track
number will be displayed.
• Hold down the TPM button until you
hear a beep.
Now the track has been stored.
With CDC operation, a “
“ symbol will ap-
pear in front of the CD name.
Then select the next track with
/ and store
with TPM, as detailed above.
You can also store a track at any time dur-
ing CD playback. For this it is necessary that
“TPM” and “SCAN” are deactivated.
Programme TPM information for other CDs
in the same way.
CD playback with TPM
• The TPM function must be switched on
(TPM on/off with the TPM button).
The tracks stored with TPM will be played
in ascending order. Any tracks which were
not stored will be skipped over.
Clearing TPM information
Using the CLR (clear) button, you can clear
single tracks, all of the tracks for one CD or
the entire Track Programme Memory.
For CDC operation, you can also clear the
TPM information of either the inserted mag-
azine or all magazines.
In order to clear any of this information, TPM
must be switched on (“TPM” lights up in the
display). If the TPM contains no data, then
“NO TPM” will appear in the display.
CD operation
a) Clearing a track from the TPM:
• Switch on TPM.
• Select the track with
/ .
• Press the CLR button for approxi-
mately two seconds until “CLR TR”
appears in the display.
Now this track has been cleared from
the TPM.
London RDM126 gb 20.06.2002, 13:45 Uhr54