Filter
Top Products
14
Detailed operating instructions
First-time installation
If the set is switched on for the first time or after the power supply has been
disconnected, FIRST INSTALL will appear in the display header.
Using this menu you can adjust the following settings:
CLOCK Set the clock
OWNER-ID Enter proof of ownership
AUX-IN Activate AUX / Enter name of auxiliary equipment
NORM SET Reset to original factory settings
Press EXIT
to exit the menu.
You can activate this menu if you switch the radio off, then press down S and
hold it while you switch the set on again.
Setting the clock
• Press
CLOCK. The current time will appear in the display header.
• Press
- HOURS / HOURS + to alter the hours and
- MIN / MIN + to alter the minutes.
When you have completed the setting,
• press EXIT
.
Entering OWNER ID
On four lines (max. 64 characters) you can enter information as proof of owner-
ship.
• Press
OWNER-ID. OWNER-ID will appear in the display header.
• Press
/ to select the characters.
S
AUX-IN
NORM SET
FIRST INSTALL
CLOCK
OWNER-ID
EXIT
S
AUX-IN
NORM SET
FIRST INSTALL
CLOCK
OWNER-ID
EXIT
S
HOURS +
MIN +
CLOCK
- HOURS
- MIN
EXIT
12:27
BA NewYork gb® 24.05.2002, 11:58 Uhr14