Filter
Top Products
43
ENGLISH DEUTSCHFRANÇAISITALIANO
NEDERLANDS
SVENSKAESPAÑOL
PORTUGUÊS
• Tune into a station with the rocker
switch (either automatically or manual-
ly).
• Press the desired preset button until
the radio resumes play after the muting
(takes approximately 2 seconds) or un-
til you hear a beep.
Now the station has been stored.
The display will indicate which station has
been stored.
Note:
If you attempt to store a station which is al-
ready stored, the corresponding station and
the station preset will flash in the display if
you are in a different memory bank.
Storing stations with the stron-
gest reception automatically
with Travelstore
You can automatically store the six FM sta-
tions with the most powerful signals in your
current reception area sorted according to
their signal strength. This function is parti-
cularly convenient on longer trips.
•
Press the “BA/TS” button for 2 seconds.
“T-STORE” will appear in the display.
The six strongest FM stations will be auto-
matically stored on the memory bank “T”
(Travelstore). When this process has been
completed, the name of the strongest stati-
on will appear in the display and begin to
play.
If desired, stations can also be stored ma-
nually in the Travelstore bank, refer to the
section on “Storing stations”.
Recalling stored stations
You can recall any stored station at the touch
of a button.
• Select the waveband by pressing BA/
TS. For FM, also choose the corre-
sponding memory bank by pressing
the BA/TS button as many times as
necessary until the desired bank ap-
pears in the display.
• Press the corresponding preset button
briefly to recall the station.
Scanning stations with Radio
Scan
You can scan through all of the stations in
your reception area.
To start the Scan function:
• Press “SC” for approximately 2 secon-
ds.
The scanned frequency or the station name
will start flashing in the display.
During the scanning process “FM-SCAN” or
“AM-SCAN” will light up in the display.
If you want to continue listening to the stati-
on which is being scanned, then
• Press “SC” briefly.
This ends the Radio Scan function.
If no station is selected, the scan function
will switch off after the frequency band has
run through. The station selected previous-
ly will resume play.
Changing the scan time
The scan time per radio station can be set
to between 5 and 20 seconds.
For more detailed information, refer to the
section on “DSC programming - SCANTI-
ME”.
Selecting the automatic tuning
sensitivity
You can alter the automatic tuning sensiti-
vity.
If “lo” is displayed, the radio will only pick up
strong, local stations (low sensitivity).
If “lo” does not light up, the radio will also
pick up weaker, more distant stations.
To switch the automatic tuning sensitivity
and program the sensitivity level, refer to the
section on “DSC programming “.