Filter
Top Products
36
9 AUD
Use this key to activate the menu for
tone control.
Treble and bass adjustment
Press “AUD” once briefly: “BASS” will
appear in the display and now you ad-
just this setting as desired by pressing
the rocker switch to the left or the right.
Use the up/down rocker switch keys to
set the treble. “TREBLE” will then ap-
pear in the display.
Setting the Balance (left/right) and
the Fader (front/rear):
Press “AUD” twice briefly.
Now use the up/down rocker switch to
adjust the volume between the front
and the rear speakers. “FADER” will
appear in the display.
Use the left/right rocker switch keys to
adjust the volume between the left and
right speakers. “BALANCE” will appear
in the display.
The selected values will appear in the
display. The last setting is stored auto-
matically.
Switch AUD off by pressing the button
again briefly.
If you do not make any adjustments to
the tone within 8 seconds, the AUD
mode will quit automatically.
LD - Loudness
Loudness boosts the bass frequency
at low volume.
Loudness on/off: Press AUD until you
hear a beep.
: DSC (Direct Software Control)
Using “DSC” you can adjust pro-
grammable basic settings to suit your
own personal preferences.
Refer to the section on “DSC pro-
gramming” for more information.
; Clock display
When the unit is switched on press
“DIS” briefly and the current time will
appear in the display for approximately
8 seconds.
Additional function for clock display:
Press and hold “DIS” until you hear a
beep to display the time permanently.
If you activate another function, the
time will disappear from the display for
approximately 8 seconds.
< Preset buttons 1 to 6
Radio mode
You can store up to six stations in
each memory bank (I, II, and “T”).
On MW and LW you can also store six
stations each.
Storing stations
Tune the radio into the station you
would like to store. Press the preset
button on which you want to store this
station (radio will switch to mute) and
hold it down until the radio becomes
audible again and you hear a beep.
Recalling stored stations
Select the waveband and, on FM the
memory bank (“I”!, “II”, or “T”) as well.
Then press the corresponding preset
button 1-6 briefly to listen to the station
stored there.
Additional function for the station
preset buttons
Storing and recalling the PTY program
type.
When PTY is active (“PTY” will appear
in the display), then you can store and
recall a program type (e.g. rock, pop,
classical, news, etc.) on each for the
station preset buttons for the FM wave-
band.
CD mode
3/
-Pause
Press the station preset button marked
3/
to interrupt CD playback. “PAU-