Filter
Top Products
26 en | Installing the Monitor High Performance LCD Monitors
F.01U.076.723 | 3.0 | 2009.03 Installation Manual Bosch Security Systems, Inc.
2. Configure the following settings for the Dinion camera:
– VMD: OSD
–Area: 1
– Active: On
3. Connect one flying lead to relay output three, on the back
of the Dinion camera, and connect the other to relay
output four.
4. Connect the other end of the Trigger Relay cable to the
Trigger Input connector on the back of the monitor.
5. Plug the monitor into a power socket; then press the
Power button.
6. On the monitor, access the Trigger menu:
a. Press the Menu button.
b. Press the Down Arrow button to access the Setup
menu.
c. Press the Right Arrow button to enter the Setup
menu.
d. Press the Down Arrow button until Trigger is
highlighted; then press the Right Arrow button.
7. Make the necessary changes to the Trigger menu so that
the settings match the following:
8. Press the Menu button three (3) times to exit the menu
and to return to the video display.
Trigger Enable On
Trigger Type External
Trigger Input AV1
Buzzer On
Trigger Time 10
Trigger Option N/O
Display Type M/C
:Move :Input :Menu
Trigger