Filter
Top Products
30 en | Navigating the Monitor High Performance LCD Monitors
F.01U.076.723 | 3.0 | 2009.03 Installation Manual Bosch Security Systems, Inc.
control. Use the front panel of the monitor or respective remote
control to make any necessary adjustments to the OSD.
To navigate the set up menus, follow the steps below:
1. Connect the CVBS or VGA cable.
2. If required, press the Input button until a signal is
displayed. NOTE: Menus are not available without a signal
applied.
3. Press the Power button to turn on the unit (see Figure 2.1
or Figure 2.2).
4. Press the Menu button to activate the main menu
selections (see Figure 2.1 or Figure 2.2).
5. Press the
and buttons to select a menu.
6. Press the Input button to enter the selected menu.
7. Press the
and buttons to select a sub-menu item.
8. Press the
and buttons to toggle the OSD values.
9. Press the Menu button to exit the selected menu and to
return to the menu bar or to confirm a selection.
10. Press the Menu button again to exit the OSD menu bar.
i
NOTICE! When you are navigating through the OSD menus, use
the Input button to select a menu and use the Menu button to
exit a menu.