Filter
Top Products
6
Connecting the Speakers (Continued)
Push down on the top of the terminal to open the hole for the wire. Insert the
wire and release the terminal to secure it. Be sure there are no loose strands of
wire. Note: there is a channel in the back of the speaker for the wire (for wires
up to 16 gauge), to keep it neat and out of sight.
Mounting the Speakers
Once you have the bracket mounted and the speaker connected the rest is easy.
1. Put the rounded end of the speaker mount in the bracket
and slide it down to lock it in place.
2. Optional – Insert and tighten the screw to secure everything.
3. Snap the cover over the bracket.
The SoundWare speakers pivot on their mounts. Vertically they can go from
facing straight out to being tilted down 40 degrees. When the flat wall mounting
bracket is used they can pivot side to side 20 degrees. (Note: Corner mounting
will not allow the speaker to pivot side-to-side.) Loosen the pivot set screw
on the front of the pivoting ball mount, pivot the speaker into position and
retighten the screw.
Subwoofer Location
Place the subwoofer on the floor near the
television.
Be careful to avoid obstructing the grille,
where the sound comes out. Also, avoid
placing the subwoofer in a position where
curtains or blankets obstruct airflow
around the rear panel.
pivots
down 40°
pivots 20°
each way
Pivot Set
Screw
1
2
3
OK