Filter
Top Products
ZRS C8
Crossover
Midrange
Tweeter
Crossover
Midrange
Tweeter
5 Channel
Configuration with 2 ohm Subwoofer
2-Ohm
Single Voice Coil
Or
To amp +
To amp -
DVC 4-Ohm
Wired in Parallel
to 2-Ohm
To amp +
To amp -
Crossover
Midrange
Tweeter
Crossover
Midrange
Tweeter
2-Ohm or 4-Ohm
6x9 or 6.5” Speakers
on Channels 3 and 4 Rear
Set the subwoofer channel 5 crossover setting to 80Hz
Low Pass and adjust the Bass Boost Equalizer to about
50%. Do not set the Low Pass crossover frequency too low.
Do not increase the Bass Boost equalizer beyond your
woofers capabilities. Plug in the remote bass control into the
jack marked REMOTE. Use only the cable which was supplied
with the amplifier.
In a full range system with passive crossovers you can set the
electronic crossovers of the ZRS C8 in the FULL RANGE
position so they receive the full frequency spectrum. You can
also choose to Bass Block the components by setting the
Crossover switches to HPF (High Pass Filter) at very low
frequencies no higher than 40-50Hz so that you protect the
smaller drivers in your system without eliminating too much of
the bass.
DVC 2-Ohm
Wired in Series
to 4-Ohm
DVC 2-Ohm
Wired in Series
to 4-Ohm
= 2-ohm
Or
SVC 4-Ohm
with two woofers
in parallel = 2-ohm
= 2-ohm
SVC 4-Ohm
with two woofers
in parallel = 2-ohm
4-Ohm
Single Voice Coil
Channel 5 can also be used
with a single 4 ohm woofer
impedance load.
DUAL WOOFER INSTALLATION CHANNEL 5
If your head unit has 3 pairs of RCA jack out puts, Front
+ Rear + Subwoofer input these in to all 6 amplifier
input jacks and set the INPUT MODE switch to the 5CH
position. If your head unit has just one pair of Sub-
woofer RCA outputs, use a “Y” adaptor for Channel 5
input.
5 CHANNEL INPUT MODE
If your head unit has 2 pairs of RCA jack out puts, Front
+ Rear input these in to Ch1, 2, 3 & 4 amplifier input
jacks and set the INPUT MODE switch to the 4CH
position .The subwoofer channel will automatically get
its signal from a mix of all four channels input signal
without the need for a separate input.
4 CHANNEL INPUT MODE
If your head unit has 1 pairs of RCA jack out puts input
them in to Ch1 and CH2 amplifier input jacks and set
the INPUT MODE switch to the 2CH position. All
amplifier channels including the subwoofer channel will
hence be driven by these two inputs without the use of
any “Y” adaptors.
2 CHANNEL INPUT MODE
FOUR CHANNEL
FADING IS RETAINED
IN THIS CONFIGURATION.
FOUR CHANNEL FADING IS RETAINED
IN THIS CONFIGURATION.
FOUR CHANNEL
FADING IS NOT AVAILABLE
IN THIS CONFIGURATION.