Filter
Top Products
CALIBRE
Issue 4.03
27/03/03 Calibre UK Ltd 2003
Page 9
PRODUCT SPECIFICATION
4.1. Introduction
This section provides technical details for all possible inputs please refer to the model
specification to determine which inputs can be displayed by the monitor.
4.6 Power Supply Requirement
Unless otherwise specified on the product the supply voltage
MUST
be from a clean
12V±1% supply.
The power supply rating depends on the requirements of the display panel, please refer to
the model specification for details.
4.2. Video Inputs
Signal formats Composite (CVBS), S-Video (Y/C), SDI, DVI
Standards NTSC, PAL, SECAM
Composite (CVBS) input level 1V p-p nominal inc. sync
Luminance (Y) input level 1V p-p nominal inc. sync
Chrominance (C) input level 0.6V p-p nominal
Input Impedance (all inputs) 75 Ohms
4.3. Computer (RGB and DVI) Inputs
Signal formats: DOS 720 x 400 70Hz
VGA 640 x 480 50Hz to 75Hz inclusive
MAC I 640 x 480 67Hz
SVGA 800 x 600 50Hz to 75Hz inclusive
MAC II 832 x 624 74.7Hz
XGA 1024 x 768 50Hz to 75Hz inclusive
MAC 2 1152 x 870 75Hz
SXGA 1152 x 900 50Hz to 75Hz inclusive
SXGA 1280 x 1024 50Hz to 75Hz inclusive
UXGA 1600 x 1200 60Hz
RGB video level 0.7V - 1.0V
RGB input impedance 75 Ohms
Sync formats
1. Separate H & V sync at TTL levels.
2. Composite -ve sync at TTL levels.
3. Sync on green (an extra 0.3V -ve on the 0.7V 75 Ohm Green video
signal)
4.4. SDI Input
Format: Serial video data in SMPTE 270Mb/s format
Input impedance: 75 ohms.
4.5. DVI Input
DVI input is via a Molex 88741 series or similar. Signals, which are in LVDS form are
input via 100-ohm differential lines using TMDS coding. Maximum pixel clock rate is
165MHz, so that the maximum transition rate on the colour signals may exceed 1.5GHz.