Filter
Top Products
Page 4 of 8 SA-365-10 Installation Instructions
05/24/10 CP5036A
OPTION SWITCHES
An 8-position DIP switch on the remote amplifier may be changed to select various options.
SW-1 Auxiliary Input Polarity - The auxiliary input is normally activated with positive, turn this
switch ON for negative activation.
SW-4 Two-Tone - Turn this switch ON to replace Phaser with Two-Tone.
SW-5 Phaser Inhibit - Turn this switch ON to disable Phaser tone. Phaser replaced with Yelp.
SW-4 and 5 Siren Tone Disable - All siren tones may be disabled except Horn by turning ON
both switches. All switches will produce Horn tone.
SW-6 Horn Inhibit - Turn this switch ON to disable Horn tone. Horn replaced with Yelp.
SW-7 Short Manual - The manual tone normally falls and dies out when the manual switch is
released. Turn this switch ON to have the tone stop immediately.
SW-8 Phaser Override - While in standby mode, the manual switch will normally activate manual
tone. Turn this switch ON to momentarily activate Phaser tone.
HORN RING CYCLER 2 (HRC2) - Turn on DIP SW-2 and SW-3 to enable this feature. Also
connect the auxiliary input to the horn ring or other switch. While the siren is in standby, tap the
horn ring to bring the unit out of standby into Wail tone. Repeatedly tapping the horn ring will
cycle through Wail, Yelp, and Phaser tones. Tapping the horn ring twice quickly will stop the siren
tones and return the unit to standby. Pressing and holding the horn ring will produce Horn tone
until released. Then the siren will return to its previous siren tone or standby.
ON
1234567 8
Option Switches
Default Setting Shown (Switches OFF)
Option Switches
On Side
SW-2 SW-3 Auxiliary Input Function
with Unit set to Standby
OFF OFF (Default) Produces Horn tone while activated.
ON OFF Produces Phaser tone while activated.
OFF ON Produces Manual siren tone.
ON ON Activates Horn Ring Cycler 2 (HRC2) function.