Filter
Top Products
CERWIN-VEGA! PROFESSIONAL
16
Using the suspension points
The P1500X suspension points are M10 threads with a depth of 25mm. Two suspension points are located on each
handle (top for vertical orientation and on the side for horizontal orientation) as well as two pull-back points located on
the rear of the unit.
CAUTION: When using suspension installation, be sure to observe the following:
Loudspeaker suspension requires qualified persons who are familiar with rigging standards and practices. Any
unsafe mounting of any heavy load can result in serious injury and equipment damage.
Consult a licensed, professional engineer regarding equipment installation and ensure that all local, state and
national regulations regarding the safety and operation of loudspeakers and related equipment are
understood and adhered to.
Do not attempt to suspend the loudspeakers by the handles.
Before loudspeaker suspension, be sure to inspect all critical points for any cracks, deformations, corrosion
and/or missing parts that may affect the strength and safety of the installation.
Only use commercially-available M10 load-rated shoulder eyebolts along with rigging hardware appropriate
for the actual load.
Fittings and rigging hardware may deteriorate over extended periods of time due to wear and/or corrosion, be
sure the installed is checked thoroughly by qualified personal at regular intervals.
Cerwin-Vega! cannot be held responsible for damage or injury caused by insufficient strength of the support
structure or improper installation.
Do not use the pull-back point as the suspension point for a majority of the load. The pull-back points are
intended for angling the loudspeaker downwards only. Note that the loudspeaker suspension points are
intended for one loudspeaker only.