Filter
Top Products
DSC920S 9
English
■
Installing location
Place the Control unit on the passenger’s seat
or stick the Velcro tape (large A) to the center
console.
∗ Before sticking the Velcro tape, clean the sticking
surface.
∗ Choose a location where the driving of a car is not
hindered and the reception of the signals from the
remote control unit is ensured as well (Figure 2).
■
How to install the Control unit
When installing the Control unit, use the Velcro
tape (small B) to secure it (Figure 3).
∗ Before sticking the Velcro tape, clean the sticking
surface.
∗ To secure the cord, use the cord holder by sticking
it to the center console, etc. (Figure 4).
Notes:
Do not leave the Control unit at a location (dash-
board, etc.) where the temperature goes high. Oth-
erwise, the unit may be deformed or damaged.
Installation of the Control unit
How to install the Control unit (in case of
using screws)
∗ Screws are not enclosed with unit.
∗ Be sure to check the screw length. (M3 x 6mm
MAX)
160
UP
55
117
3 9
2
2 – ø3.5
Dashboard
Velcro tape
(large A)
Fig 2
Velcro tape
(small B)
Control unit
Fig 3
Cord holder
Fig 4