23
English
DXZ465MP
• Displaying the Satelite ID No.
∗ The factory default setting is the upper 6 digits.
2-1. Select “ SID DISP”.
3-1. Turn the
[
ROTARY
]
knob to switch between
the display for the upper 6 digits and the
lower 6 digits.
• OFF:
Use with inside AMP.
• Setting the external amplifier
∗ The factory default setting is “OFF”.
2-1. Select “ AMP CANCEL”.
3-1. Turn the
[
ROTARY
]
knob to select “ON” or
“OFF”.
Operations Common to Each Mode
• Performing a system check
This function allows you to perform a system check
from the adjust mode when required.
2-1. Select “ SYSTEM CHECK ”.
3-1. Press and hold the
[
]
button for 1 second
or longer.
“SYSTEM CHECK” appears in the display,
then the unit returns to the previous
operation mode.
To change other settings
1. Press the
[
ADJ
]
button to switch to the
adjustment selection display.
2. Press the
[ , ]
lever upward or
downward to select the “item name”.
Each time the
[ , ]
lever is pressed up/
down, the item display changes in the following
order:
“
BLINK LED” “AMP CANCEL”
(
“SID DISP”
)
“AUX SENS”
“SYSTEM CHECK ”
∗ SID DISP function only applies when a Satelite
receiver is connected.
3. Turn the
[
ROTARY
]
knob to select the “desired
setting item”.
∗ After completing settings, press the
[
ADJ
]
but-
ton to return to the previous mode.
• Anti-theft indicator
The red Anti-theft indicator is a function for pre-
venting theft. When the DCP is removed from the
unit, this indicator blinks.
∗ The factory default setting is “OFF”.
2-1. Select “ BLINK LED”.
3-1. Turn the
[
ROTARY
]
knob to select “ON” or
“OFF”.
• ON:
Use with connected AMP.
Triggered audio mute for cellular
telephones
This unit requires special wiring to mute the audio
signal automatically when a cellular telephone
rings in the car.
∗ This function is not compatible with all cellular
telephones. Contact your local authorized Clarion
dealer for information on proper installation and
compatibility.
•
Adjusting the display scroll speed
This feature allows you to slow down the scroll
speed when the scroll speed is too fast, making it
difficult to view the screen.
∗ The factory default setting is “SPEED 3”
2-1. Select “ SCRL SPEED”.
3-1. Turn the
[
ROTARY
]
knob to select the setting.
∗ This setting item can be adjusted within the
range SPEED 1 to SPEED 6.
Adjust this setting item while viewing how the
appearance of the display changes.
• Dimmer control
You can setting the dimmer control “ON” or “OFF”.
∗ The factory default setting is “ON”.
2-1. Select “ DIMMER”.
3-1. Turn the
[
ROTARY
]
knob to select “ON” or
“OFF”.
• Adjusting the display contrast
You can adjust the display contrast to match the
angle of installation of the unit.
∗ The factory default setting is “08”.
(
Adjustment level: 01 to 16
)
2-1. Select “ CONTRAST”.
3-1. Turn the
[
ROTARY
]
knob to adjust the
contrast.
Push ENT
Push ENT