Filter
Top Products
FOR BRIDGED (MONO) MODE
Note: For bridged mono mode, we recommend a total load of 4 or 8 ohms.
1. Connect the front left positive ("+") speaker output of the amplifier to the positive input terminal
of the speaker.
2. Connect the front right negative ("–") speaker output of the amplifier to the negative input termi-
nal of the speaker.
3. Repeat the same for the rear channel.
4. Make sure that ALL RCAs (front and rear left/right) are plugged in, other wise bass response
and output will suffer.
Figure 11: Bridged Single Woofer Connection
CAUTION: ANY DEVIATION FROM THE ABOVE SPEAKER CONNECTION MAY CAUSE
SERIOUS DAMAGE TO THE AMPLIFIER AND/OR SPEAKERS. PLEASE DOUBLE CHECK THE
CONNECTION BEFORE TURNING THE SYSTEM ON.
COUSTIC.COM
11
INSTALLATION continued
INPUT CONNECTIONS
Connect the front and rear RCA input jacks of the Amplifier to the outputs of the Source Unit (i.e.,
radio, cassette player or CD player). If line level output is not available, connect the speaker out-
puts of the source unit to the Speaker Level input of the amplifier.
Figure 9: High/Low Impedance Inputs
Note: Connect the black ground wire to the source unit ground only if alternator noise is
present.
Connect the Amplifier to the Speakers. Use thicker speaker wires (e.g. 8 - 10 gauge desirable) for
these connections.
FOR STEREO MODE
Note: We recommend a total speaker load of 2, 4 or 8 ohms per channel
1. Connect the front left negative ("–") speaker output of the amplifier to the negative terminal of
the left speaker.
2. Connect the front left positive ("+") speaker output of the amplifier to the positive terminal of
the left speaker.
3. Connect the front right ("–") speaker output of the amplifier to the negative terminal of the right
speaker.
4. Connect the front right ("+") speaker output of the amplifier to the positive terminal of the right
speaker.
5. Repeat the same for the rear channel speaker connections.
Figure 10: Stereo Connection
+ L - + R -
BRIDGE
BRIDGE
+ L - + R -
FRONT
REAR
+ L - + R -
BRIDGE
BRIDGE
+ L - + R -
FRONT
REAR
RIGHT REAR(green) +
FRONT
SPKR LEVEL
L
R
SENS
MIN MAX
MODE
HPF OFF LPF
OUTPUT FRONT REAR
INPUT
LEFT FRONT(wht/blk) -
LEFT FRONT(white) +
RIGHT FRONT(blu/blk) -
RIGHT FRONT(blue) +
LEFT REAR(yel/blk) -
LEFT REAR(yellow) +
RIGHT REAR(grn/blk) -
GROUND (black)