Crown Audio XLC2500 Car Amplifier User Manual


 
XLC Series Power Ampliers
XLC系列功率放大器
page 10
Operation Manual
操作手册
2.7 Wiring Your System
2.7.1 Stereo Mode
Typical input and output stereo wiring is shown in figure 2.10. If you need to know which frequence (high, middle or low)
that the Channel 1 or Channel 2 corresponds to, please refer to the appendix in the operation manual of CXM2000.
1. Set the Mode Switch to Stereo (1-OFF, 2-OFF).
2. Connect Channel 1 loudspeaker’s positive (+) lead to Channel 1 positive (red) terminal of amp; repeat for negative
(-). Repeat Channel 2 wiring as for Channel 1.
2.7.2 Parallel Mode
Typical input and output bridge wiring is shown in figure 2.11.
1. Set the Mode Switch to Parallel (1-ON, 2-OFF).
2. Connect Channel 1 loudspeaker’s positive (+) lead to Channel 1 positive (red) terminal of amp; repeat for negative
(-). Repeat Channel 2 wiring as for Channel 1.
2.7 连接系统
2.7.1 立体声模式
图2.10为一个常用的立体声输入和输出接线示例。有关如何区分通道1和通道2对应的高中低频,
请参看CXM2000操作手册后面的附录。
1. 将后面板的模式开关设定到立体声位置(1-OFF, 2-OFF);
2. 将通道1扬声器的正极(+)导线连接到功放通道1的正极(红色)端子上,用同样的方法,
连接好通道1的负极。使用与通道1同样的方法,连接好通道2。
2.7.2 并行模式
图2.11为一个常用的并行输入和输出接线示例。
1. 将后面板的模式开关设定到并行位置(1-ON, 2-OFF);
2. 将通道1扬声器的正极(+)导线连接到功放桥接的正极(红色)端子上,用同样的方法,
连接好通道1的负极。使用与通道1同样的方法,连接好通道2。
JBL 3252
H
O
T
A
I
R
E
X
H
A
U
S
T
ON
1 2
ON
1 2
-
-
+
+
Ch. 1 amplifier output to LF driver
Stereo: 1-OFF, 2-OFF
Ch. 1 SourceCh. 2 Source
Ch. 2 amplifier output to HF
and MF driver
Figure 2.11 Parallel Mode
图2.11 并行模式
Figure 2.10 Stereo Mode
图2.10 立体声模式
2. 安装(接上一页)
2. Setup (continued)
H
O
T
A
I
R
E
X
H
A
U
S
T
ON
1 2
ON
1 2
Parallel: 1-ON, 2-OFF
Ch. 1 Source
JBL 4181JBL 4181
- -
+ +