Dell E2010H Car Video System User Manual


  Open as PDF
of 30
 
Back to Contents Page
Setting Up the Monitor
Dell™E2010H/E2210H/E2310H Flat Panel Monitor User's Guide
Attaching the Stand
Connecting Your Monitor
Attaching the Dell Soundbar (Optional)
RemovingtheStandBase
Wallmounting(Optional)
Attaching the Stand
Connecting Your Monitor
To connect your monitor to the computer:
1. Turnoffyourcomputeranddisconnectthepowercable.
2. Connect either the white (digital DVI-D) or the blue (analog VGA) display connector cable to the corresponding video port on the back of your
computer.Donotconnectbothcablesonthesamecomputer. Use both the cables only when they are connected to two different computers with
appropriate video systems
Connecting the VGA Cable
Connecting the DVI Cable
NOTE: The stand is detached when the monitor is shipped from the factory.
Remove the monitor cover and place the monitor on it.
1.
Fit two tabs on the upper part of the stand to the groove on the back of the monitor.
2.
Lower the monitor so that the monitor mounting area snaps onto the stand.
CAUTION: Before you begin any of the procedures in this section, follow the Safety Instructions.
 previous next