Filter
Top Products
7
© 2003 Directed Electronics, Inc
WOOFER INSTALLATION
1. Mark and cut a 7-5/8” (186mm)
hole for mounting the speaker.
2. Drill the holes for the mounting
screws using a 1/8” (3mm) drill
bit.
3. Route the wiring harness through the
mounting hole.
4. Install the spring clips over the
holes if needed. Apply the rear
mounting gasket to the speaker
frame.
5. Attach the wires to the speaker and
be sure to observe proper speaker
polarity.
6. Place the woofer in the hole. Insert
screws through grill clips and
woofer mounting holes. Screw
woofer into place using the six
supplied mounting screws and grill
clips.
7. Press the speaker grill firmly in
place over the grill mounting clips.
FIGURE 1—WOOFER INSTALLATION