Filter
Top Products
6
Installation in a Vehicle: Running the Antenna Cable
1. Turn SR200’s power off and remove it from the cradle; unplug the cigarette lighter adapter from the cigarette
lighter; unplug the antenna from the cradle.
2. Route the cable from the antenna to the vehicle’s interior by tucking it underneath the rubber molding around rear
window, as shown below.
3. Route the cable from the lowest point of the rear window into the trunk. Take advantage of any existing cable
channels or wiring conduits.
• For SUVs, minvans, and 5-door vehicles, bring the cable into the vehicle under the rubber molding for the
tailgate, and continue under the interior trim.
4. From the trunk, route the cable around the passenger compartment and to the back of the cradle.
• Do not pull the wire across sharp edges that could damage it.
• Keep the wire away from areas where it could become tangled in driver’s and passenger’s feet.
5. Plug the antenna into the back of cradle where it says ANT.
6. Plug the cigarette lighter adapter into the cigarette lighter.
Note: Do not leave the cigarette lighter adapter plugged in after you turn the vehicle’s ignition off.