Dual MXD254B Car Stereo System User Manual


  Open as PDF
of 12
 
5
General Operation
Press RELEASE and pull away from the left side to remove.
To re-install, insert right side of faceplate first then push left
side to secure.
Remove trim ring and install supplied #1 x 7/32” Phillips head
screw through left side of mounting frame into faceplate.
Press PWR to turn the unit on. Inserting a CD will turn the
unit on automatically. Press PWR to turn the unit off.
Press MODE to select between AM/FM, CD or auxiliary input.
Modes of operation are indicated in the display.
Press and hold LOUD for 2 seconds to activate and deactivate
the loud feature. Activating this feature will enhance the
bassandtreblefrequencieswhenlisteningtomusicatlow
volumes.
Insert a 3.5mm connector in the front panel AUX port.
Connect the other end of the 3.5mm connector to the
headphone output of an audio device, MP3 player, etc. Press
MODE to select AUX mode.
Adjustvolumeusingthe rotary encoder (00-46).
Press DISPtodisplaytheclock.Theradiofrequency(tuner
mode)andCDtrack/elapsedtime(CDplayermode)willbe
shown by default.
Press DISPtodisplaytheclock,thenrelease.Pressand
hold DISPfor2seconds,theclockwillbegintoflash.Press
TRACK
nn
toadjustthehoursandTRACK
ll
toadjust
theminutes.Clocksettingswillbesavedafter5seconds.
Theclockwilldisplay12-hourAM/PMtimeinUSAfrequency
spacingmode(PM10:00).InEuropeanfrequencyspacing
mode,theclockwilldisplay24-hourtime(22:00).
Press and hold for more than 2 seconds to RESET the unit
upon initial installation. The RESET button is located behind
the faceplate.
Faceplate Removal
Semi-permanent Faceplate
Installation
Power On/Off
Mode
Loud
Auxiliary Input
Volume
Display
Set the Clock
12/24-hour Clock
Reset
MXD254B OPERATION
 previous next