Filter
Top Products
Remote Turn-On
Connect to amplifier or power
antenna. Insulate wire if not used.
RCA Cable
(sold separately)
Antenna
Connector
BLUE
Rear Preamp Output
Connect to amplifier RCA Input
GRAY
Ground
Connect to vehicle
chassis ground.
BLACK
Accessory
Connect to existing ignition
circuit or switched 12 volt source.
RED
Memory
Connect to battery
circuit or constant 12 volt source.
1 AMP
AGC Fuse
5 AMP
AGC Fuse
Right Front
Gray/Black (-)
Gray (+)
Left Front
White/Black (-)
White (+)
Right Rear
Violet/Black (-)
Violet (+)
Left Rear
Green/Black (-)
Green (+)
YELLOW
AMP
XD5110 INSTALLATION
Wiring
Diagram
4
FUSES
When replacing fuses,
make sure new fuse is the
correct type and amperage.
Using an incorrect fuse
could damage the radio.
The XD5110 uses one 1
amp AGC fuse (Ignition)
and one 5 amp AGC fuse
(Battery) located in-line.
* CAUTION - Do not attach any speaker leads to ground as severe damage will occur.