Filter
Top Products
Before operation
6 Dynaudio Acoustics BM9S
Connecting the subwoofer
Subwoofer inputs
The BM9S provides two different signal inputs:
LFE/Slave IN
This input allows the LFE (Low Frequency Effect) channel to be connected.
The signal is:
• reproduced by the subwoofer
• routed to the Slave OUT for a second subwoofer to be connected.
The SUB Lowpass control has no impact on this input.
SAT/SUB IN
This input allows the connection of a full bandwidth signal.
The signal is:
• reproduced by the subwoofer,
• routed to the SAT/SUB OUT terminals. Low frequencies are cut-off according to
the SAT Highpass setting,
• routed to the Slave OUT for a second subwoofer to be connected. High
frequencies are cut-off according to the SUB Lowpass setting.
CAUTION
DAMAGE OF DEVICE DUE TO IMPROPER CONNECTION!
X Set the mains power switch to OFF before connecting the BM9S.
X Only switch the subwoofer on (mains power switch to ON) after all connections
and set up steps have been properly completed.
+
+
LFE
Slave
SAT/SUB IN
SAT/SUB OUTSlave OUT
LFE/Slave IN
Subwoofer
+
SUB
Lowpass
SAT
Highpass
Gain
Phase
Mode