Eclipse - Fujitsu Ten CD1000 Car Stereo System User Manual


 
How to operate the AUDIO CONTROL
21
VII
How to operate the AUDIO CONTROL
Switching audio control modes
Various audio control modes may be fine-tuned using this procedure.
Modes will switch in the order shown below each time the button is pressed.
VOL BASS TREB FAD BAL LOUD VOL www
ATTENTION
If you change the "AMP GAIN" setting from "HIGH PWR" to "LOW PWR" while the volume
level is set higher than "VOL 30," the receiver automatically changes the volume level to "VOL
30."
• Pressing the [MUTE] button briefly will cut the volume or restore it instantly.
1
Press the [MODE] button to select the item to be adjusted.
WARNING
Do not adjust the volume or other controls while driving the vehicle. Do so only while parked in a
safe location.
Mode Function
[AUDIO CONTROL] button
Turn to the Left Turn to the Right
VOL (VOLUME) Adjusts volume.
Decreases the
volume.
Increases the
volume.
BASS
Adjusts bass level. Bass mode can be
adjusted for each source
Softens low sounds.
Emphasizes low
sounds.
TREB (TREBLE)
Adjusts treble level. Treble mode can be
adjusted for each source
Softens high sounds.
Emphasizes high
sounds.
FAD (FADER) Adjusts front/rear speaker balance.
Emphasizes rear
speakers.
Emphasizes front
speakers.
BAL (BALANCE)
Adjusts left/right speaker balance.
Emphasizes left
speakers.
Emphasizes right
speakers.
LOUD
The loudness control may be turned on to
emphasize low and high frequencies at
low volume levels.
Loudness compensates for the apparent
weakness of low and high frequencies at
low volume by boosting the bass and
treble levels.
Turn the loudness control ON/OFF.
VI