Filter
Top Products
ESN security operating procedure
61
X
ATTENTION
If a CD has already been inserted, a "SEC"
message appears, and then the front panel
opens and the CD is ejected.
"CANCEL" will be displayed and the
CD will be ejected. ESN is now
deactivated.
ATTENTION
If a CD other than the Key CD is inserted, the
registration cannot be cancelled. In this case,
the "ERR" message is displayed for two
seconds, and the CD playback mode is
activated.
The front panel closes.
How to change the Key CD
Refer to "How to cancel the Key CD".
Refer to "How to program the Key
CD".
How to resume normal operation
(ESN security lock out)
If power is disconnected while ESN security is
active (a Key CD was programmed),
operation is disabled until power is restored
and the main unit unlocked. Follow this
procedure to resume normal operation.
"OK" will be displayed for two seconds
and the CD will begin playing.
ATTENTION
• If the incorrect CD is inserted, an "ERR_ "
(“ERR” and error number) message will
appear for two seconds, after which the CD
will be ejected.
• If the "ERR5" (the 5th time an error has
occurred) message appears on the display,
the "HELP" message will appear, and the
CD will be ejected. When the "HELP"
message appears, carry out the operations
for ESN security lock out by following the
procedure in "What happens if an incorrect
CD is inserted?" on page 61.
• You must be use the same CD used for Key
CD programming; a duplicate CD may not
work properly.
What happens if an incorrect CD is
inserted?
"HELP" will be displayed for 5
seconds. Then the serial number will
be displayed.
4
Insert the Key CD into the disc slot.
5
Press the [ e (OPEN/EJECT)]
button.
1
First, cancel the existing Key CD.
2
Next, program a new Key CD.
1
When the power is turned on after
the battery power has been
disconnected, the "SEC" message
is displayed for two seconds. The
message then changes to the
"DISC" message. Press the [e
(OPEN/EJECT)] button.
2
Insert the Key CD into the disc slot.
1
After the 5th incorrect attempt, the
"HELP" message will be displayed
for five seconds.
2
Press the [e (OPEN/EJECT)]
button to close the front panel.