Filter
Top Products
ELECTRO-VOICE
®
Owner’s Manual
Using Two-Way
S
x
AA
AA
A
Systems as Floor Monitors
S
x
A two-way systems are perfect for use as powered floor monitors.
The correct projection angle is already incorporated into the enclosure design of the S
x
A250.
Simply turn the S
x
A250 on its side and operate the system in the same manner as described
above. The F200 adapters are necessary to convert the S
x
A100+ into a monitor and are
shipped with the speaker. To install the adapters, simply insert them into the speaker (See
Figure 8 below). The F200 adapters can be easily removed by pulling in the opposite
direction.
The F200 Monitor Foot kit contains two plastic feet.
The F200 is used with any 12-inch S
x
or S
x
A
speaker enclosures.
Insert the feet firmly into the holes in the rear cabinet (See Figure 8).
Remove the F200 monitor feet by pulling in the opposite direction.
FIGURE 8:
Installing the F200 Monitor Foot on SxA100+ Speaker
CAUTION: The F200 monitor feet protrude from the enclosure. Care should be taken
when moving the enclosure, since damage to the feet or enclosure might occur if the
system is dropped or slid across a rough surface. It is recommended that the feet be
removed for transport.
MONITOR
FOOT
“O” RING
LOCATION
PERMANENT SCREW
LOCATION
11 ELECTRO-VOICE
®
Owner’s Manual