Filter
Top Products
ELECTRO-VOICE
®
Owner’s Manual
Figure 3:
Microphone Input Connections
& Connections To Additional Systems
Setup Diagrams for
S
x
AA
AA
A
Two-Way Systems
To use the S
x
A two-way system for various applications:
·
Plug a microphone into the microphone input connector (See Figure 3). It will only accept
low-impedance dynamic microphones terminated with a standard 3-pin XLR-type
connector. Turn the gain control clockwise until the signal present LED stays on with the
input signal at normal operational level. Adjust the master gain control to the desired
overall output level.
·
Plug a line input into either the ¼-inch or the 3-pin XLR-type input connector. Examples
of line input sources are mixer outputs, CD/DVD players, cassette decks, VCRs,
electronic keyboards, computer sound cards, etc. The ¼- inch input is in the center of the
XLR connector and can accept unbalanced or balanced lines (TRS ¼-inch). The line input
level required to drive the unit to full power is from – 12 dBu to 0 dBu. The system’s
master gain control regulates the overall output level of the system.
THRU Output
ELECTRO-VOICE
®
Owner’s Manual 6