Filter
Top Products
WARNING
The cable that links the positive (+) terminal to the battery at the amplifier’s “+ BATT” binding post terminal
must ABSOLUTELY be fused (see current ratings listed in the table on page 19) not more than 40cm from the
vehicle’s battery. The connections on the fuse-holder must be fully insulated.
3.7.1 - You can now start the fuse-holder (the role of which is to make the system safe) installation phase.
The fuse-holder must be connected on both sides to the positive (+) power supply cable. It has to be near
the battery (i.e. 10cm - 40cm from the battery). Disassemble the fuse-holder, taking care to remove the fuse.
Attach the base of the fuse-holder. Cut the red power supply cable at a distance of between 10cm and 40cm
(maximum) from the battery. Retain the cable you do not use here, as it will be used later, to link the other end
of the fuse-holder to the positive (+) terminal of the vehicle’s battery. Strip 1cm of the cable end, then tin it.
Screw the cable into the fuse-holder binding post terminal. Do not throw away the spare cable that is left over.
Strip 1cm of the cable end, then tin it. Screw the cable into the other fuse-holder binding post terminal (fig. 7).
Note: The FP 5.500 amplifier use internal fuses (as opposed to other amplifiers witch have fuses on the rear
panel). Replacing these components requires opening the bottom cover of the amplifier. Only a Focal dealer
is authorized to change this component. Thank you for bringing the amplifier back to your dealer in order to
place the fuse, so to avoid any risk of electric shock, product damage or voidance of guarantee.
WARNING
Do not open the amplifier or undertake any modifications to the product. There is a risk of accident, fire or
electric shock.
3.7.2 - THE FOLLOWING PROCEDURE IS INTENTED TO FOCAL DEALER ONLY. DO NOT CHANGE THE
FUSE BY YOURSELF.
FP 5.500 fuse replacement procedure:
- Switch off the amplifier and the other components of the car audio system.
- Disconnect the positive terminal of the battery powering the amplifier.
- Unscrew the fixing screws of the amplifier.
- Turn the amplifier upside down, bear in mind that wires musn’t get twisted or crushed.
- Unscrew the screws securing the bottom cover of the amplifier.
- Take the cover off.
- Remove the blown fuses.
fig. 7
40 cm max
10
installation
notice amplis focal power gb.ind10 10notice amplis focal power gb.ind10 10 28/09/06 16:11:5828/09/06 16:11:58